Curriculum is designed to impart appropriate knowledge and skill and inculcate moral standard in students of a particular course of study. In tertiary institutions of learning like polytechnic and university curricula of some courses are in three parts: theory, practical and exposure to industrial work experience just to produce competent graduates. The objective of this paper is assessing adequacy of valuation practical knowledge already acquired by HND II students in the Department of Estate Management and Valuation, The Federal Polytechnic, Ilaro and its main significance is to gauge ability to measure and determine areas of buildings accurately for valuation purposes, a prerequisite to cost method of valuation. Research Methodology adopted for the test is physical demonstration of the acquired knowledge by all the 45 students under close supervision. They were grouped into five and each group under a lecturer-supervisor was assigned to measure, read and record and calculate areas of buildings on campus. The exercise revealed that they were not adept in handling measuring instrument - tape rule, reading of its figures, producing graphic drawings and calculating areas of existing buildings of different shapes with 71.1%, 55.6%, 88.9% and 66.7% failure rates respectively. But 100% success rate was achieved in recording of measurement figures. These lapses exposed deficiency of either or both the lecturers or/and students involved in teaching and learning at the institution. The paper recommended that lecturers should pay adequate attention to their duty while students should focus on their learning being their primary assignment on campus.